Landcruiser AWD L6-4.5L (1FZ-FE) (1997)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position Sensor (NE2 Signal)
COMPONENTS FOR REMOVAL AND INSTALLATION
CRANKSHAFT POSITION SENSOR (NE2 SIGNAL) REMOVAL
1. Remove engine under cover.
2. Remove crankshaft position sensor protector.
Remove the 3 bolts and crankshaft position sensor protector.
Torque: 20 N.m (200 kgf.cm, 14 ft.lbf)
3. Disconnect crankshaft position sensor bracket and connector.
4. Remove crankshaft position sensor.
(a) Remove the bolt, 2 nuts and crankshaft position sensor.
Torque:
Bolt A: 20 N.m (200 kgf.cm, 14 ft.lbf)
Nut B: 9 N.m (90 kgf.cm, 78 in..lbf)
CRANKSHAFT POSITION SENSOR (NE2 SIGNAL) INSTALLATION
INSTALLATION HINT: Installation is in the reverse order of removal.
NOTE: For (NE Signal) Sensor see: Distributor Removal.
See: Ignition System/Distributor/Service and Repair