Landcruiser AWD L6-4.5L (1FZ-FE) (1997)
/Page-1810002.png)
1. Secure the gear assembly on the 09630 - 00014 (09631 - 00142) Special Service Tool (SST) and clamp the SST in a vise.
2. Remove the adjusting screw lock nut and seal washer.
3. Remove the side cover by performing the following.
a. Remove the four bolts.
b. Turn the cross shaft adjusting screw clockwise until the cover comes off.
c. Remove the O-ring from the cover.
4. Remove the cross shaft by using a plastic hammer, tap on the cross shaft end and pull out the shaft.
5. Remove power piston plunger guide. nut, compression spring, power piston plunger and power piston plunger guide by performing the following.
a. Using a hexagon wrench (10 mm), remove the plunger guide nut.
b. Remove the O-ring from the plunger guide nut.
6. Remove the worm gear valve body assembly by performing the following.
a. Remove the four bolts.
b. Using the 09616 - 00010 SST, turn the valve body shaft clockwise with holding the worm gear by your finger so it cannot move.
