Landcruiser AWD L6-4.5L (1FZ-FE) (1997)
Wheel Bearing: Service and Repair
Rear
REAR AXLE HUB REMOVAL
1. To remove the rear axle hub, first remove the rear wheel.
2. Remove the rear axle shaft.
3. Remove the brake caliper and disc.
4. Disconnect the ABS speed sensor by first removing the bolt, then disconnecting the ABS speed sensor.
5. Remove the rear axle bearing lock nut by performing the following. Remove the 2 screws from the lock nut then, using the 09509 - 25011 SST,
remove the lock nut.
6. Remove the rear axle hub by first pulling out the axle hub, after removing the lock nut plate and outer bearing, then removing the axle hub.
REAR AXLE HUB BEARING AND 0IL SEAL REPLACEMENT
1. Using the 09308 - 00010 Special Service Tool (SST), remove the oil seal then remove the inner bearing from the hub.