Landcruiser AWD L6-4.5L (1FZ-FE) (1997)
/Page-1510024.png)
2.33 mm (0 0917 inch).
15. Remove companion flange.
16. Remove oil slinger and rear bearing.
17. Remove rear bearing outer race and oil storage ring.
18. Install the bearing spacer and rear bearing by performing the following:
a. Install a new bearing spacer on the shaft.
b. Install a new oil storage ring and rear bearing outer race.
c. Install the rear bearing and oil slinger.
19. Using the 09214 - 76011 SST and a hammer, install a new oil seal, as shown. The oil seal drive in depth is 1.0 mm (0.039 inch). Apply MP grease
to the oil seal lip.
20. Install the companion flange by following the steps listed below.
a. Install the companion flange by using the 09550 - 30010 (09951 - 03010, 09953 - 03010, 09954 - 03010, 09955 - 03030, 09956 - 03020)
SSTs.
b. Install the plate washer and a new nut taking care to coat the threads of a new nut with hypoid gear oil.
c. Using the 09330 - 00021 SST to hold the flange then tighten the nut to 196 Nm (145 ft. lbs.).
