Matrix 4WD L4-1.8L (1ZZ-FE) (2004)
/Page-1219001.png)
Keyless Entry Receiver: Testing and Inspection
CHECK DOOR CONTROL RECEIVER
(a) Disconnect the D6 connector from the door control receiver.
(b) Check the continuity and voltage between the terminals of the door control receiver connector and the body ground, as shown in the illustration
and table.
If the result is not as specified, there may be a malfunction on the wire harness side.
(c) Reconnect the connector and check the voltage between the terminal and body ground.
If the result is not as specified, the receiver may have a malfunction.
