Matrix FWD L4-1.8L (2ZR-FE) (2010)
2. Place pieces of foam (PIN 63355-12060 / 63356-12040) near the snap-fit positions of the dome lamp assembly cover as indicated in Figures 1-4
below.
Overview of Foam
NOTE
^
It may be necessary to cut the foam.
^
Only if the foam is damaged or unusable, use the following dimensions and cut a NEW piece from the Interior Noise Kit (P/N 08231-00801).
A. Install foam into the dome lamp assembly in the areas shown in Figure 3.
3. Remove headliner.