Matrix FWD L4-1.8L (2ZR-FE) (2010)
/Page-1358005.png)
NOTICE:
*
Do not damage the brake lines or wire harness.
*
Do not carry the brake actuator assembly by the connector.
10. REMOVE BRAKE ACTUATOR
(a) Remove the 3 bolts and brake actuator from the brake actuator bracket assembly.
Installation
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: BRAKE ACTUATOR (w/o VSC): INSTALLATION
1. INSTALL BRAKE ACTUATOR
(a) Install the brake actuator to the brake actuator bracket assembly with the 3 bolts.
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
NOTICE:
*
Do not remove the hole plugs of a new brake actuator before connecting the 6 brake lines because the brake actuator is filled with
brake fluid.
