Matrix FWD L4-1.8L (2ZR-FE) (2010)
/Page-1393004.png)
4. REMOVE REAR FLEXIBLE HOSE (for Double Wishbone Type Suspension)
(a) Remove the union bolt and gasket, and separate the rear flexible hose from the rear disc brake cylinder assembly.
(b) Using a union nut wrench (10 mm), disconnect the brake line while holding the rear flexible hose with a wrench.
NOTICE:
*
Do not kink or damage the brake line.
*
Do not allow any foreign matter such as dirt and dust to enter the brake line.
(c) Remove the clip and rear flexible hose.
Installation
BRAKE (REAR): REAR BRAKE FLEXIBLE HOSE: INSTALLATION
NOTICE:
*
Because the left and right rear flexible hoses are not interchangeable, verify the part number when installing the flexible hoses.
*
If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.
1. INSTALL REAR FLEXIBLE HOSE (for Torsion Beam Type Suspension)
(a) Install the rear flexible hose with a new clip.
NOTICE:
Install the clip as far as it will go.
(b) Using a union nut wrench (10 mm), connect the brake line to the rear flexible hose while holding the rear flexible hose with a wrench.
