Matrix FWD L4-1.8L (2ZR-FE) (2010)
Water Pump: Service and Repair
Installation
2ZR-FE COOLING: WATER PUMP: INSTALLATION
1. INSTALL WATER PUMP ASSEMBLY
(a) Align the protrusion of a new water pump gasket with the cutout in the timing chain cover and install the gasket to the groove of the timing
chain cover.
HINT
Be sure to clean the contact surfaces.
(b) Install the water pump assembly to the timing chain cover with the 5 bolts.
Bolt A - Torque : 26 Nm (260 kgf-cm, 19 ft-lbf)
Bolt B - Torque : 24 Nm (245 kgf-cm, 18 ft-lbf)
Bolt Length:
2. INSTALL GENERATOR ASSEMBLY See: Starting and Charging/Charging System/Alternator/Service and Repair/Removal and
Replacement/Installation
3. INSTALL V-RIBBED BELT See: Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair/Installation
4. ADJUST V-RIBBED BELT See: Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair/Installation
5. INSPECT V-RIBBED BELT See: Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Testing and Inspection
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
7. ADD ENGINE COOLANT See: Coolant/Service and Repair
8. INSPECT FOR COOLANT LEAK See: Testing and Inspection
9. INSTALL ENGINE UNDER COVER RH
10. INSTALL NO. 2 CYLINDER HEAD COVER See: Engine/Service and Repair/Removal and Replacement/Engine Assembly/Installation