Matrix FWD L4-1.8L (2ZR-FE) (2010)
Hazard Warning Switch: Testing and Inspection
LIGHTING (EXT): HAZARD WARNING SWITCH: INSPECTION
1. INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(b) If the result is not as specified, replace the switch.
(c) Connect a positive (+) lead from the battery to terminal 3 and a negative (-) lead to terminal 2.
(d) Check that the illumination of the switch comes on.
OK:
The illumination comes on.
(e) If the result is not as specified, replace the switch.