Matrix FWD L4-1.8L (2ZR-FE) (2010)
(b) Measure the distance from the RH lower suspension arm bracket set bolt to the LH axle carrier rear side set bolt as shown in the illustration.
(c) Employ the same manner to the LH-RH.
Length difference:
6.0 mm (0.236 in.) or less
(d) If the difference exceeds the specified value, adjust it by turning the adjusting cams.
(e) Loosen the upper and lower suspension arm adjusting cam set nuts.
(f) Adjust the camber and toe-in by turning the adjusting cams.
HINT
Try to adjust the camber and toe-in to the center of the specified values.
(g) Tighten the upper and lower suspension arm adjusting cam set nuts.
Torque : 74 Nm (755 kgf-cm, 55 ft-lbf)