Matrix FWD L4-1.8L (2ZR-FE) (2010)
Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.
18. REMOVE REAR DISC (for Double Wishbone Type Suspension) See: Brakes and Traction Control/Disc Brake System/Service and
Repair/Overhaul/Rear Brake (for Double Wishbone Type Suspension)/Reassembly
19. REMOVE NO. 3 PARKING BRAKE SHOE RETURN TENSION SPRING (for Double Wishbone Type Suspension) See: Brakes and Traction
Control/Parking Brake System/Service and Repair/Disassembly
20. REMOVE NO. 2 PARKING BRAKE SHOE RETURN TENSION SPRING (for Double Wishbone Type Suspension) See: Brakes and Traction
Control/Parking Brake System/Service and Repair/Disassembly
21. REMOVE NO. 1 PARKING BRAKE SHOE HOLD DOWN COMPRESSION SPRING (for Double Wishbone Type Suspension) See: Brakes
and Traction Control/Parking Brake System/Service and Repair/Disassembly
22. REMOVE PARKING BRAKE SHOE STRUT (for Double Wishbone Type Suspension) See: Brakes and Traction Control/Parking Brake
System/Service and Repair/Disassembly
23. SEPARATE NO. 2 PARKING BRAKE SHOE HOLD DOWN COMPRESSION SPRING (for Double Wishbone Type Suspension) See: Brakes
and Traction Control/Parking Brake System/Service and Repair/Disassembly
24. SEPARATE PARKING BRAKE SHOE LEVER (for Double Wishbone Type Suspension) See: Brakes and Traction Control/Parking Brake
System/Service and Repair/Disassembly
25. REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET (for Double Wishbone Type Suspension) See: Brakes and Traction
Control/Parking Brake System/Service and Repair/Disassembly
26. REMOVE NO. 1 PARKING BRAKE SHOE RETURN TENSION SPRING (for Double Wishbone Type Suspension) See: Brakes and Traction
Control/Parking Brake System/Service and Repair/Disassembly
27. REMOVE PARKING BRAKE SHOE LEVER (for Double Wishbone Type Suspension) See: Brakes and Traction Control/Parking Brake
System/Service and Repair/Disassembly
28. REMOVE REAR AXLE HUB BOLT (for Double Wishbone Type Suspension)
(a) Temporarily install the 2 nuts and 2 washers to the rear axle hub bolt as shown in the illustration.
(b) Using SST and a brass bar or an equivalent tool to hold the hub and bearing assembly, remove the rear axle hub bolt.
SST : 09628-10011
29. INSTALL REAR AXLE HUB BOLT (for Double Wishbone Type Suspension)
(a) Install a washer and nut to a new rear axle hub bolt as shown in the illustration.