Matrix FWD L4-1.8L (2ZR-FE) (2010)
/Page-910058.png)
HINT
The resistance must be measured after the CAN No. 1 junction connector is disconnected.
Standard resistance:
NG -- CHECK FOR SHORT TO B+ IN CAN BUS WIRE (CAN NO. 1 JUNCTION CONNECTOR - NETWORK GATEWAY
ECU)
OK -- Continue to next step.
14. CHECK FOR SHORT TO B+ IN CAN BUS WIRE (4WD CONTROL ECU BRANCH WIRE)
(a) Measure the resistance according to the value(s) in the table below.
HINT
The resistance must be measured after the CAN No. 1 junction connector is disconnected.
Standard resistance:
