Matrix FWD L4-1.8L (2ZR-FE) (2010)
/Page-925004.png)
(b) Turn the ignition switch to ON.
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
NG -- CHECK HARNESS AND CONNECTOR (COMBINATION METER - ECM)
OK -- REPLACE ECM See: Engine Control Module/Service and Repair/Removal
7. CHECK HARNESS AND CONNECTOR (COMBINATION METER - ECM)
(a) Disconnect the combination meter connector.
(b) Disconnect the ECM connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance (Check for Open):
