Matrix FWD L4-1.8L (2ZR-FE) (2010)
/Page-1031007.png)
(g) Perform the following procedure when connecting a fuel tube connector (quick type B):
(1) Line up the two parts of the pipes to be connected, and fully push the fuel tube connector and pipe together until they are fully seated. Push
the retainer into the connector until its claws lock. If the pipe is difficult to push into the connector, apply a small amount of clean engine
oil to the tip of the pipe and reinsert it.
(2) After connecting, check that the pipe and connector are securely connected by pulling on them.
(3) Check for fuel leaks.
(h) Perform the following procedure when disconnecting the fuel tube connector (quick type C):
(1) Check the pipe and around the connector for dirt and mud before disconnecting them. Clean them if necessary.
(2) Remove the checker of the fuel tube connector from the pipe.
(3) Pinch the tabs of the retainer of the fuel tube connector to disengage the lock claws and slide it as shown in the illustration.
(4) Check the sealing surface of the disconnected pipe for dirt and mud. Clean them away if necessary.
(5) Cover the disconnected fuel tube connector and pipe with a plastic bag to prevent damage and contamination.
(i) Perform the following procedure when connecting the fuel tube connector (quick type C):
