Matrix FWD L4-1.8L (2ZR-FE) (2010)
Camshaft Position Sensor: Service and Repair
Removal
2ZR-FE ENGINE CONTROL: CAMSHAFT POSITION SENSOR: REMOVAL
HINT
Although the part name refers to the No. 1 crank position sensors, this procedure is for the camshaft position sensors.
1. REMOVE NO. 2 CYLINDER HEAD COVER See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal
2. REMOVE NO. 1 CRANK POSITION SENSOR
(a) Exhaust camshaft side:
(1) Disconnect the duty vacuum switching valve connector and 3 engine wire harness clamps.
(2) Disconnect the No. 1 crank position sensor connector.
(3) Remove the bolt and No. 1 crank position sensor.
(b) Intake camshaft side:
(1) Disconnect the No. 1 crank position sensor connector.
(2) Remove the bolt and No. 1 crank position sensor.