Matrix FWD L4-1.8L (2ZR-FE) (2010)
(a) Disconnect the heated oxygen sensor connector.
(b) Remove the grommet and pull the sensor connector out of the cabin through the floor panel.
(c) Remove the wire harness clamp bracket and disconnect the wire harness clamp.
(d) Using SST, remove the heated oxygen sensor.
SST : 09224-00010
Installation
2ZR-FE ENGINE CONTROL: HEATED OXYGEN SENSOR: INSTALLATION
1. INSTALL HEATED OXYGEN SENSOR
(a) Using SST, install the heated oxygen sensor onto the front exhaust pipe.
SST : 09224-00010
without SST - Torque : 44 Nm (449 kgf-cm, 32 ft-lbf)
with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)
NOTICE: