Matrix FWD L4-1.8L (2ZR-FE) (2010)
/Page-797003.png)
*
This torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.81 in.) and SST with
measurement of 30 mm (1.18 in.) See: Service Precautions.
*
This torque value is effective when SST is parallel to the torque wrench.
(b) Install the wire harness clamp bracket and connect the wire harness clamp.
(c) Pass the sensor connector through the floor panel and install the grommet.
(d) Connect the heated oxygen sensor connector.
2. INSPECT FOR EXHAUST GAS LEAK
