Matrix FWD L4-1.8L (2ZR-FE) (2010)
Tire Pressure Module: Service and Repair
Installation
TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING ECU: INSTALLATION
1. INSTALL TIRE PRESSURE WARNING ECU
(a) Connect the connector to the tire pressure warning ECU.
(b) Install the tire pressure warning ECU with the screw.
HINT
Engage the pin into the hole as shown in the illustration to install the tire pressure warning ECU.
2. INSTALL AIR CONDITIONING PANEL ASSEMBLY
HINT
Refer to the instructions for Installation of the air conditioning panel See: Heating and Air Conditioning/Control Assembly/Service
and Repair/Removal and Replacement/Installation.
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. REGISTER TRANSMITTER ID
HINT
It is necessary to register all transmitter IDs See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring
System/Testing and Inspection/Programming and Relearning/Registration.
5. INSPECT TIRE PRESSURE WARNING SYSTEM
See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring System/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Test Mode Procedure
6. INITIALIZE SYSTEM
See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring System/Testing and Inspection/Programming and
Relearning/Initialization
NOTICE:
*
Be sure to register the transmitter IDs of all tires in the ECU before initialization.
*
Be sure to inflate all tires to the proper inflation pressure before initialization.