Matrix FWD L4-1.8L (2ZR-FE) (2010)
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
3. REMOVE FRONT BUMPER ASSEMBLY (w/o Front Spoiler) See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Removal
4. REMOVE FRONT BUMPER ASSEMBLY (w/ Front Spoiler) See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Removal
5. REMOVE FRONT BUMPER ENERGY ABSORBER See: Body and Frame/Bumper/Front Bumper/Service and Repair/Overhaul/Disassembly
6. REMOVE FRONT AIRBAG SENSOR
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Disconnect the connector from the front airbag sensor.
NOTICE:
When disconnecting the airbag connector, take care not to damage the airbag wire harness.
(d) Remove the bolt and disengage the pin, and remove the front airbag sensor.
NOTICE:
Loosen the bolt while holding the front airbag sensor because the front airbag sensor pin (stopper) is easily damaged.
Installation
SUPPLEMENTAL RESTRAINT SYSTEMS: FRONT AIRBAG SENSOR: INSTALLATION
1. INSTALL FRONT AIRBAG SENSOR
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Align the pin of the front airbag sensor to the body hole.