Matrix FWD L4-1.8L (2ZR-FE) (2010)
Neutral Safety Switch: Service and Repair
Installation
U341E AUTOMATIC TRANSMISSION / TRANSAXLE: PARK / NEUTRAL POSITION SWITCH: INSTALLATION
1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a) Install the park/neutral position switch assembly to the automatic transaxle.
(b) Temporarily install the 2 bolts.
(c) Replace the lock plate with a new one and tighten the manual valve shaft nut.
Torque : 6.9 Nm (70 kgf-cm, 61 in-lbf)
(d) Temporarily install the control shaft lever.
(e) Turn the lever counterclockwise until it stops, then turn it clockwise 2 notches.
(f) Remove the control shaft lever.
(g) Align the groove with the neutral basic line.
(h) Hold the switch in this position and tighten the 2 bolts.
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)