Matrix FWD L4-1.8L (2ZR-FE) (2010)
(b) Remove the ST relay from the No. 8 relay block.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance (Check for Open):
Standard Resistance (Check for Short):
(d) Reconnect the park/neutral position switch connector.
(e) Reinstall the ST relay.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (ST RELAY - PARK/NEUTRAL POSITION SWITCH)
OK -- REPLACE ECM See: Powertrain Management/Computers and Control Systems/Engine Control Module/Service and
Repair/Removal
10. INSPECT CLUTCH PEDAL SWITCH
(a) Inspect the clutch pedal switch See: Powertrain Management/Transmission Control Systems/Sensors and Switches - Transmission and
Drivetrain/Sensors and Switches - M/T/Clutch Pedal Position Sensor / Switch/Testing and Inspection.
NG -- REPLACE CLUTCH PEDAL SWITCH See: Powertrain Management/Transmission Control Systems/Sensors and Switches -
Transmission and Drivetrain/Sensors and Switches - M/T/Clutch Pedal Position Sensor / Switch/Service and Repair/Removal
OK -- Continue to next step.
11. CHECK HARNESS AND CONNECTOR (IGNITION SWITCH ASSEMBLY - CLUTCH PEDAL SWITCH)
(a) Disconnect the clutch pedal switch connector.