Matrix FWD L4-1.8L (2ZR-FE) (2010)
/Page-1241002.png)
Standard Resistance:
(b) If the value is not as specified, replace the shift solenoid valve S2.
(c) Connect a positive (+) battery lead to the terminal of the solenoid connector, and a negative (-) battery lead to the solenoid body, and check the
operation of the valve.
NOTICE:
When using battery voltage during the inspection, do not bring the positive and negative tester probes too close to each other as a
short circuit may occur.
OK:
The solenoid makes an operating sound.
(d) If the operation cannot be done as specified, replace the shift solenoid valve S2.
3. INSPECT SHIFT SOLENOID VALVE ST
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
