Matrix FWD L4-1.8L (2ZR-FE) (2010)
HINT
If it is difficult to disengage the fitting, tap the end of the drive shaft with a brass bar and a hammer.
(b) Push the front axle assembly LH out of the vehicle to remove the drive shaft from the front axle assembly LH.
NOTICE:
*
Do not push out the front axle further than necessary.
*
Do not damage the outboard joint boot.
*
Do not damage the speed sensor rotor.
17. SEPARATE FRONT AXLE ASSEMBLY RH
HINT
Use the same procedure for the LH side.
18. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
(a) Using SST, remove the front drive shaft assembly LH.
SST : 09520-01010
SST : 09520-24010
09520-32040
NOTICE:
*
Do not damage the oil seal.
*
Do not damage the inboard joint boot.
*
Do not drop the drive shaft.
19. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
(a) Using a brass bar and a hammer, remove the front drive shaft assembly RH.