Matrix FWD L4-1.8L (2ZR-FE) (2010)
Shift Cable: Service and Repair
Installation
C59 MANUAL TRANSMISSION / TRANSAXLE: TRANSMISSION CONTROL CABLE: INSTALLATION
1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Install the transmission control cable assembly with the 2 nuts.
Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)
(b) Install the transmission control cable assembly with the nut.
Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)
(c) Install the 2 transmission control cables to the control cable bracket with 2 new clips*1.
(d) Install the 2 transmission control cables to the transaxle with the 2 clips*2.
(e) Rotate the transmission control cable nut counterclockwise approximately 180° and, while holding the nut in that position, press in the stopper
until it makes 2 "click" sounds.