Matrix FWD L4-2.4L (2AZ-FE) (2009)
Front Cross-Member: Service and Repair
Installation
FRONT SUSPENSION: FRONT SUSPENSION MEMBER (for 2WD): INSTALLATION
INSTALLATION
1. INSTALL FRONT STABILIZER BAR See: Steering and Suspension/Suspension/Stabilizer Bar/Service and Repair/Front Stabilizer
Bar/Installation
2. INSTALL STEERING LINK ASSEMBLY See: Steering and Suspension/Steering/Steering Gear/Service and Repair/Installation
3. TEMPORARILY INSTALL FRONT LOWER SUSPENSION ARM LH See: Steering and Suspension/Suspension/Control Arm/Service and
Repair/Front Lower Suspension Arm/Installation
4. TEMPORARILY INSTALL FRONT LOWER SUSPENSION ARM RH
HINT: Perform the same procedure as the LH side.
5. INSTALL FRONT SUSPENSION MEMBER DYNAMIC DAMPER (for 2ZR-FE)
(a) Install the front suspension member dynamic damper.
6. TEMPORARILY INSTALL CENTER ENGINE MOUNTING MEMBER SUB-ASSEMBLY
(a) Temporarily install the center engine mounting member sub-assembly with the 4 bolts.
7. INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY
(a) While alternately inserting SST into the reference holes on the front suspension crossmember RH and LH, tighten the 2 bolts (A), 2 bolts (B),
2 bolts (C), bolt (D) and 3 nuts (E) on the RH and LH sides to the respective specified torque in several steps.
SST: 09670-00010