Matrix FWD L4-2.4L (2AZ-FE) (2009)
/Page-2192003.png)
(a) Install the front hook assembly with the 2 bolts.
Torque: 39 Nm (398 kgf-cm, 29 ft-lbf)
10. CONNECT FRONT LOWER SUSPENSION ARM LH See: Steering and Suspension/Suspension/Ball Joint/Service and Repair/Installation
11. CONNECT FRONT LOWER SUSPENSION ARM RH
HINT: Perform the same procedure as the LH side.
12. CONNECT FRONT STABILIZER LINK ASSEMBLY LH See: Steering and Suspension/Suspension/Suspension Strut / Shock Absorber/Service
and Repair/Front Shock Absorber/Installation
13. CONNECT FRONT STABILIZER LINK ASSEMBLY RH
HINT: Perform the same procedure as the LH side.
14. CONNECT TIE ROD END SUB-ASSEMBLY LH See: Steering and Suspension/Steering/Steering Gear/Service and Repair/Installation
15. CONNECT TIE ROD END SUB-ASSEMBLY RH
HINT: Perform the same procedure as the LH side.
16. INSTALL ENGINE UNDER COVER LH
17. INSTALL ENGINE UNDER COVER RH
18. CONNECT NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY See: Steering and Suspension/Steering/Steering Gear/Service and
Repair/Installation
19. CONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY See: Steering and Suspension/Steering/Steering Column/Service and
Repair/Removal and Replacement/Installation
20. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
21. INSTALL COLUMN HOLE COVER SILENCER SHEET See: Steering and Suspension/Steering/Steering Column/Service and Repair/Removal
and Replacement/Installation
22. INSTALL FRONT WHEELS
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)
23. STABILIZE SUSPENSION See: Steering and Suspension/Suspension/Control Arm/Service and Repair/Front Lower Suspension Arm/Installation
24. FULLY TIGHTEN FRONT LOWER SUSPENSION ARM LH See: Steering and Suspension/Suspension/Control Arm/Service and Repair/Front
Lower Suspension Arm/Installation
25. FULLY TIGHTEN FRONT LOWER SUSPENSION ARM RH
HINT: Perform the same procedure as the LH side.
26. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
HINT: Inspect and adjust front wheel alignment See: Maintenance/Alignment/Service and Repair/Front Wheel Alignment.
