toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Components|Page 7392 > < Components|Page 7390
Page 3
background image

15. TEMPORARILY TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY RH

HINT:  Perform the same procedure for the LH side.

16. INSTALL REAR FLOOR SIDE MEMBER BRACE See: Steering and Suspension/Suspension/Control Arm/Service and Repair/Rear Lower

Arm/Installation

17. INSTALL REAR DRIVE SHAFT SNAP RING LH (for 4WD) 
18. INSTALL REAR DRIVE SHAFT ASSEMBLY LH (for 4WD) 
19. INSTALL REAR DRIVE SHAFT SNAP RING RH (for 4WD)

HINT:  Perform the same procedure for the LH side.

20. INSTALL REAR DRIVE SHAFT ASSEMBLY RH (for 4WD)

HINT:  Perform the same procedure for the LH side.

21. INSTALL REAR AXLE ASSEMBLY LH (for 2WD)
22. INSTALL REAR AXLE ASSEMBLY RH (for 2WD)
23. INSTALL REAR AXLE ASSEMBLY LH (for 4WD) See: Maintenance/Wheels and Tires/Wheel Hub/Service and Repair/Rear Axle Hub (for

Double Wishbone Type Suspension)/Installation

24. INSTALL REAR AXLE ASSEMBLY RH (for 4WD)

HINT:  Perform the same procedure for the LH side.

25. TEMPORARILY TIGHTEN UPPER CONTROL ARM ASSEMBLY LH 
26. TEMPORARILY TIGHTEN UPPER CONTROL ARM ASSEMBLY RH

HINT:  Perform the same procedure for the LH side.

27. TEMPORARILY TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY LH 
28. TEMPORARILY TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY RH

HINT:  Perform the same procedure for the LH side.

29. INSTALL REAR STABILIZER LINK ASSEMBLY LH 
30. INSTALL REAR STABILIZER LINK ASSEMBLY RH

HINT:  Perform the same procedure for the LH side.

31. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY

(a) Install the No. 3 parking brake cable assembly with the bolt.

Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)

NOTE:  Do not twist the No. 3 parking brake cable assembly when installing it.

(b) Install the No. 3 parking brake cable assembly with the 2 bolts.

Torque: 6.0 Nm (61 kgf-cm, 53 in-lbf)

NOTE:  Do not twist the No. 3 parking brake cable assembly when installing it.

32. INSTALL NO. 2 PARKING BRAKE CABLE ASSEMBLY

HINT:  Perform the same procedure for the No. 3 parking brake cable assembly.

33. APPLY HIGH TEMPERATURE GREASE (for LH Side) See: Brakes and Traction Control/Parking Brake System/Service and

Components|Page 7392 > < Components|Page 7390