toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Removal and Replacement|Page 4541 > < Removal and Replacement|Page 4539
Page 9
background image

(d) Engage the clamp and connect the connector.

3. CONNECT CLUTCH TUBE (for Manual Transaxle)

(a) Connect the clutch tube to the brake master cylinder reservoir assembly with the clip.

4. FILL RESERVOIR WITH BRAKE FLUID See: Brake Fluid/Service and Repair
5. BLEED CLUTCH LINE (for C59) See: Transmission and Drivetrain/Clutch/Service and Repair/Procedures
6. BLEED CLUTCH LINE (for E351) See: Transmission and Drivetrain/Clutch/Service and Repair/Procedures
7. BLEED BRAKE MASTER CYLINDER See: Brake Bleeding/Service and Repair
8. BLEED BRAKE LINE See: Brake Fluid/Service and Repair
9. BLEED BRAKE ACTUATOR (w/ VSC) See: Brake Bleeding/Service and Repair

10. INSPECT FOR BRAKE FLUID LEAK
11. INSPECT FLUID LEVEL See: Brake Fluid/Testing and Inspection
12. INSTALL AIR CLEANER CASE (for 2ZR-FE) See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine

Assembly/Installation

13. INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH HOSE (for 2ZR-FE) See: Powertrain Management/Fuel Delivery and Air

Induction/Throttle Body/Service and Repair/Installation

14. INSTALL NO. 2 CYLINDER HEAD COVER (for 2ZR-FE) See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and

Replacement/Engine Assembly/Installation

15. INSTALL AIR CLEANER CASE (for 2AZ-FE) See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine

Assembly/Installation

16. INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH HOSE (for 2AZ-FE) See: Powertrain Management/Fuel Delivery and Air

Induction/Throttle Body/Service and Repair/Installation

17. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY (for 2AZ-FE) See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and

Replacement/Engine Assembly/Installation

18. INSTALL SUSPENSION TOWER DAMPER ASSEMBLY (w/ Front Strut Bar) See: Body and Frame/Frame/Strut Tower Brace/Service and

Repair/Installation

19. INSTALL OUTER COWL TOP PANEL

(a) Install the outer cowl top panel with the 12 bolts.

Torque: 8.8 Nm (90 kgf-cm, 78 in-lbf)

(b) Engage the clamp.

Removal and Replacement|Page 4541 > < Removal and Replacement|Page 4539