toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Parking Brake Lever > < Parking Brake Cable (for Double Wishbone Type Suspension)|Page 4579
Page 15
background image

(a) Install the upper No. 1 front floor heat insulator with the 3 nuts.

Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)

7. INSTALL FRONT EXHAUST PIPE ASSEMBLY (for 2ZR-FE) See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Manifold/Service

and Repair/Installation

8. INSTALL CENTER EXHAUST PIPE ASSEMBLY (for 2AZ-FE) See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Manifold/Service

and Repair/Installation

9. INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY See: Parking Brake Lever/Service and Repair/Installation

10. INSTALL PARKING BRAKE CABLE END STOPPER See: Parking Brake Lever/Service and Repair/Installation
11. INSTALL PARKING BRAKE EQUALIZER See: Parking Brake Lever/Service and Repair/Installation
12. INSTALL PARKING BRAKE LEVER ASSEMBLY See: Parking Brake Lever/Service and Repair/Installation
13. CONNECT PARKING BRAKE EQUALIZER See: Parking Brake Lever/Service and Repair/Installation
14. INSTALL NO. 3 BELT ANCHOR REINFORCEMENT SUB-ASSEMBLY See: Parking Brake Lever/Service and Repair/Installation
15. INSTALL NO. 2 BELT ANCHOR REINFORCEMENT SUB-ASSEMBLY See: Parking Brake Lever/Service and Repair/Installation
16. ADJUST PARKING BRAKE TRAVEL See: Adjustments
17. INSTALL FRONT CONSOLE BOX ASSEMBLY

HINT:  Refer to the instructions for Installation of the front console box  See: Body and Frame/Interior Moulding / Trim/Console/Service and
Repair/Installation.

18. INSTALL FRONT SEAT ASSEMBLY LH

HINT:  Refer to the instructions for Installation of the front seat assembly (w/o Seatback Board)  See: Body and Frame/Seats/Service and
Repair/Front Seat Assembly (w/o Seatback Board)/Installation.

19. INSTALL FRONT SEAT ASSEMBLY RH (w/o Seatback Board)

HINT:  Perform the same procedure for the LH side.

20. INSTALL FRONT SEAT ASSEMBLY RH (w/ Seatback Board)

HINT:  Refer to the instructions for Installation of the front seat assembly (w/ Seatback Board)  See: Body and Frame/Seats/Service and
Repair/Front Seat Assembly (w/ Seatback Board)/Installation.

21. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)
22. INSPECT SRS WARNING LIGHT (w/ Front Seat Side Airbag)  See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial

Inspection and Diagnostic Overview/Diagnosis System

23. INSPECT FOR EXHAUST GAS LEAK
24. INSTALL REAR WHEEL

Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)

Parking Brake Lever > < Parking Brake Cable (for Double Wishbone Type Suspension)|Page 4579