Matrix FWD L4-2.4L (2AZ-FE) (2009)
(b) Install a new gasket and the chain tensioner with the 2 nuts.
Torque: 9.0 Nm (92 kgf-cm, 80 in-lbf)
NOTE: When installing the chain tensioner, set the hook again if the hook releases the plunger.
20. INSTALL V-RIBBED BELT TENSIONER ASSEMBLY
(a) Except spring type V-ribbed belt tensioner:
(1) Install the V-ribbed belt tensioner assembly with the bolt and nut.
Torque: 60 Nm (607 kgf-cm, 44 ft-lbf)
(b) Spring type V-ribbed belt tensioner:
(1) Install the V-ribbed belt tensioner to the engine by first tightening the bolt and then tightening the nut.
Torque: 60 Nm (607 kgf-cm, 44 ft-lbf)
NOTE: When replacing the V-ribbed belt tensioner with a new one, do not pull out the pin.
21. INSTALL CRANKSHAFT PULLEY
(a) Using SST, secure the pulley in place and tighten the bolt.
SST: 09213-54015
91651-60855
SST: 09330-00021
Torque: 180 Nm (1835 kgf-cm, 133 ft-lbf)