Matrix FWD L4-2.4L (2AZ-FE) (2009)
Torque: 43 Nm (440 kgf-cm, 32 ft-lbf)
10. INSTALL CENTER EXHAUST PIPE ASSEMBLY (for 4WD)
(a) Using a vernier caliper, measure the free length of the compression spring.
If the free length is less than the minimum, replace the compression spring.
(b) Fully insert a new gasket to the center exhaust pipe assembly.
NOTICE:
-
Be sure to install the gasket in the correct direction.
-
Do not reuse the gasket.
-
Do not damage the gasket.
(c) Install a new gasket to the front exhaust pipe assembly.
(d) Connect the center exhaust pipe assembly to the 3 exhaust pipe supports.