Matrix FWD L4-2.4L (2AZ-FE) (2009)
Fuel Gauge Sender: Service and Repair
Removal
2AZ-FE FUEL: FUEL SENDER GAUGE ASSEMBLY: REMOVAL
REMOVAL
1. DISCHARGE FUEL SYSTEM PRESSURE
(a) Discharge fuel system pressure See: Powertrain Management/Fuel Delivery and Air Induction/Service Precautions/Technician Safety
Information/Fuel System Precaution.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
3. REMOVE FUEL SUCTION TUBE ASSEMBLY
(a) Remove the fuel suction tube assembly from the fuel tank assembly See: Powertrain Management/Fuel Delivery and Air Induction/Fuel
Pump/Service and Repair/Removal and Replacement/Removal.
4. REMOVE FUEL SENDER GAUGE ASSEMBLY (for 4WD)
(a) Disconnect the fuel sender gauge connector.
NOTE: Do not damage the wire harness.
(b) Release the lock and slide the fuel sender gauge assembly to remove it.
NOTE: Make sure that the fuel sender gauge arm does not bend.
5. REMOVE FUEL SENDER GAUGE ASSEMBLY (for 2WD)
(a) Disconnect the fuel sender gauge connector.
NOTE: Do not damage the wire harness.
(b) Release the lock and slide the fuel sender gauge assembly to remove it.
NOTE: Make sure that the fuel sender gauge arm does not bend.
6. REMOVE NO. 2 REAR FLOOR SERVICE HOLE COVER (for 4WD)
(a) Remove the rear floor service hole cover.
7. REMOVE FUEL SENDER GAUGE RH ASSEMBLY (for 4WD)