Matrix FWD L4-2.4L (2AZ-FE) (2009)
Hazard Warning Switch: Testing and Inspection
LIGHTING (EXT): HAZARD WARNING SWITCH: INSPECTION
INSPECTION
1. INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
If the result is not as specified, replace the switch.
(b) Connect a positive (+) lead from the battery to terminal 3 and a negative (-) lead to terminal 2.
(c) Check that the illumination of the switch comes on.
OK:
The illumination comes on.
If the result is not as specified, replace the switch.