Matrix FWD L4-2.4L (2AZ-FE) (2009)
/Page-950005.png)
-
The following DTC is output only for current malfunctions.
(d) 4WD CONTROL ECU (for 4WD)
HINT: DTC communication uses the CAN system.
(e) NETWORK GATEWAY ECU
HINT: DTC communication uses the CAN system.
(f) ECM
HINT: The ECM is connected to the CAN communication system, but CAN communication DTCs are not output.
(g) CENTER AIRBAG SENSOR
HINT: The center airbag sensor is connected to the CAN communication system, but CAN communication DTCs are not output.
(h) STEERING ANGLE SENSOR
HINT: The steering angle sensor is connected to the CAN communication system, but CAN communication DTCs are not output.
(i) YAW RATE SENSOR
HINT: The yaw rate sensor is connected to the CAN communication system, but CAN communication DTCs are not output.
(j) COMBINATION METER
HINT: The combination meter is connected to the CAN communication system, but CAN communication DTCs are not output.
(k) MAIN BODY ECU
HINT: The main body ECU is connected to the CAN communication system, but CAN communication DTCs are not output.
4. DTC COMBINATION TABLE
(a) CAN No. 1 Bus
HINT:
-
o: Set
-
X: Not set or may be set according to the malfunctioning part when one side of the CAN bus wire opens
-
*1: Does not output it during communication error
