Matrix FWD L4-2.4L (2AZ-FE) (2009)
Clockspring Assembly / Spiral Cable: Service and Repair
Installation
SUPPLEMENTAL RESTRAINT SYSTEMS: SPIRAL CABLE: INSTALLATION
INSTALLATION
1. INSTALL SPIRAL CABLE (w/o VSC)
(a) Check that the front wheels are facing straight ahead.
(b) Set the turn signal switch to the neutral position.
NOTE: If it is not in the neutral position, the turn signal switch pin may be snapped.
(c) Install the spiral cable with the 3 claws.
NOTE: When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.
(d) Connect the connectors to the spiral cable.
NOTE: When connecting the airbag connector, take care not to damage the airbag wire harness.
2. INSTALL SPIRAL CABLE (w/ VSC)
(a) Engage the 6 claws and 2 pins, and install the spiral cable to the steering angle sensor.
3. INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR (w/ VSC)
(a) Check that the front wheels are facing straight ahead.
(b) Set the turn signal switch to the neutral position.
NOTE: If it is not in the neutral position, the turn signal switch pin may be snapped.