Matrix FWD L4-2.4L (2AZ-FE) (2009)
Seat Position Sensor: Service and Repair
Installation
SUPPLEMENTAL RESTRAINT SYSTEMS: SEAT POSITION SENSOR: INSTALLATION
INSTALLATION
1. INSTALL SEAT POSITION SENSOR
(a) Install the seat position sensor to the seat slide position sensor protector with the pin as shown in the illustration.
(b) Using a 1.3 mm (0.0512 in.) feeler gauge, set the seat position sensor.
NOTICE:
-
If the seat position sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat
position sensor with a new one.
-
When installing the seat position sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched
between other parts.
HINT: Be sure that the clearance between the seat position sensor and the seat rail is within 0.6 to 2.0 mm (0.0236 to 0.0787 in.).