Matrix FWD L4-2.4L (2AZ-FE) (2009)
Removal
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR (for 2WD): REMOVAL
REMOVAL
HINT:
-
Use the same procedure for the RH side and LH side.
-
The procedure listed below is for the LH side.
-
If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly with rear speed sensor.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE FRONT UPPER CONSOLE BOX (for Torsion Beam Type Suspension) See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Lower Instrument Panel/Removal
3. LOOSEN PARKING BRAKE CABLE (for Torsion Beam Type Suspension) See: Brakes and Traction Control/Disc Brake System/Service and