Matrix FWD L4-2.4L (2AZ-FE) (2009)
(i) Using a screwdriver, stake the nut with the lock plate.
(j) Install the control shaft lever with the washer and nut.
Torque: 13 Nm (130 kgf-cm, 9 ft-lbf)
(k) Connect the park/neutral position switch connector.
2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Connect the transmission control cable to the bracket with a new clip.
(b) Connect the transmission control cable assembly to the control shaft lever with the nut.
Torque: 12 Nm (122 kgf-cm, 9 ft-lbf)
3. INSTALL BATTERY CARRIER See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Installation
4. INSTALL BATTERY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine Assembly/Installation
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine Assembly/Installation
6. INSPECT SHIFT LEVER POSITION See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shift Linkage/Shift
Cable/Adjustments
7. ADJUST SHIFT LEVER POSITION See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shift Linkage/Shift Cable/Adjustments
8. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY See: Testing and Inspection/On-Vehicle Inspection