Matrix FWD L4-2.4L (2AZ-FE) (2009)
/Page-1565004.png)
(1) Using a screwdriver, hold the brush springs back, and install the 4 brushes into the brush holder.
(2) Insert the grommet between the positive (+) pole and negative (-) pole.
4. INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY
(a) Fit the clamp of the brush holder into the starter commutator end frame assembly.
(b) Install the commutator end frame with the 2 screws.
Torque: 1.5 Nm (15 kgf-cm, 13 in-lbf)
5. INSTALL STARTER ARMATURE PLATE
(a) Install the starter armature plate onto the starter yoke assembly.
(b) Install the starter plate so that the keyway is positioned between the keys.
