Matrix FWD L4-2.4L (2AZ-FE) (2009)
(b) Remove the 2 bolts, 2 nuts, and rear axle beam assembly.
NOTE: Since stopper nuts are used, loosen the bolts.
25. REMOVE REAR AXLE CARRIER BUSHING LH
(a) Place matchmarks on the 2 notches of the rear axle carrier bushing and rear axle beam assembly.
(b) Using a chisel and hammer, bend the 2 portions of the rear axle carrier bushing rib.
NOTICE:
-
When removing the rear axle carrier bushing, do not erase the matchmarks on the rear axle beam assembly.
-
If the axle beam has been scratched, apply paint to the axle beam assembly.
(c) Using SST, remove the rear axle carrier bushing from the rear axle beam assembly.
SST: 09950-40011
09951-04020
09952-04010
09953-04030
09954-04020
09955-04051
09957-04010
09958-04011
SST: 09950-60010
09951-00630
26. REMOVE REAR AXLE CARRIER BUSHING RH
HINT: Perform the same procedure as the LH side.