Matrix FWD L4-2.4L (2AZ-FE) (2009)
/Page-1764003.png)
15. TEMPORARILY TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY RH
HINT: Perform the same procedure for the LH side.
16. INSTALL REAR FLOOR SIDE MEMBER BRACE See: Control Arm/Service and Repair/Rear Lower Arm/Installation
17. INSTALL REAR DRIVE SHAFT SNAP RING LH (for 4WD)
18. INSTALL REAR DRIVE SHAFT ASSEMBLY LH (for 4WD)
19. INSTALL REAR DRIVE SHAFT SNAP RING RH (for 4WD)
HINT: Perform the same procedure for the LH side.
20. INSTALL REAR DRIVE SHAFT ASSEMBLY RH (for 4WD)
HINT: Perform the same procedure for the LH side.
21. INSTALL REAR AXLE ASSEMBLY LH (for 2WD)
22. INSTALL REAR AXLE ASSEMBLY RH (for 2WD)
23. INSTALL REAR AXLE ASSEMBLY LH (for 4WD) See: Wheel Hub/Service and Repair/Rear Axle Hub (for Double Wishbone Type
Suspension)/Installation
24. INSTALL REAR AXLE ASSEMBLY RH (for 4WD)
HINT: Perform the same procedure for the LH side.
25. TEMPORARILY TIGHTEN UPPER CONTROL ARM ASSEMBLY LH
26. TEMPORARILY TIGHTEN UPPER CONTROL ARM ASSEMBLY RH
HINT: Perform the same procedure for the LH side.
27. TEMPORARILY TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY LH
28. TEMPORARILY TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY RH
HINT: Perform the same procedure for the LH side.
29. INSTALL REAR STABILIZER LINK ASSEMBLY LH
30. INSTALL REAR STABILIZER LINK ASSEMBLY RH
HINT: Perform the same procedure for the LH side.
31. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY
(a) Install the No. 3 parking brake cable assembly with the bolt.
Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)
NOTE: Do not twist the No. 3 parking brake cable assembly when installing it.
(b) Install the No. 3 parking brake cable assembly with the 2 bolts.
Torque: 6.0 Nm (61 kgf-cm, 53 in-lbf)
NOTE: Do not twist the No. 3 parking brake cable assembly when installing it.
32. INSTALL NO. 2 PARKING BRAKE CABLE ASSEMBLY
HINT: Perform the same procedure for the No. 3 parking brake cable assembly.
33. APPLY HIGH TEMPERATURE GREASE (for LH Side) See: Brakes and Traction Control/Parking Brake System/Service and
Repair/Reassembly
