Matrix FWD L4-2.4L (2AZ-FE) (2009)
Tire Pressure Module: Service and Repair
Installation
TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING ECU: INSTALLATION
INSTALLATION
1. INSTALL TIRE PRESSURE WARNING ECU
(a) Connect the connector to the tire pressure warning ECU.
(b) Install the tire pressure warning ECU with the screw.
HINT: Engage the pin into the hole as shown in the illustration to install the tire pressure warning ECU.
2. INSTALL AIR CONDITIONING PANEL ASSEMBLY
HINT: Refer to the instructions for Installation of the air conditioning panel See: Heating and Air Conditioning/Control Assembly/Service
and Repair/Installation.
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. REGISTER TRANSMITTER ID
HINT: It is necessary to register all transmitter IDs See: Tire Monitoring System/Testing and Inspection/Programming and
Relearning/Registration.
5. INSPECT TIRE PRESSURE WARNING SYSTEM See: Tire Monitoring System/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Test Mode Procedure
6. INITIALIZE SYSTEM See: Tire Monitoring System/Testing and Inspection/Programming and Relearning/Initialization
NOTICE:
-
Be sure to register the transmitter IDs of all tires in the ECU before initialization.
-
Be sure to inflate all tires to the proper inflation pressure before initialization.