Matrix FWD L4-2.4L (2AZ-FE) (2009)
Transmission Speed Sensor: Service and Repair
Removal
U250E AUTOMATIC TRANSMISSION / TRANSAXLE: SPEED SENSOR: REMOVAL
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine Assembly/Removal
3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and
Repair/Removal
4. REMOVE AIR CLEANER CASE See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal
5. REMOVE BATTERY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine Assembly/Removal
6. REMOVE BATTERY CARRIER See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal
7. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY
(a) Remove the transmission oil level gauge sub-assembly.
(b) Disconnect the transmission wire connector, park/neutral position switch connector and 2 wire harness clamps.
(c) Remove the bolt and transmission oil filler tube sub-assembly.
(d) Remove the O-ring from the transmission oil filler tube sub-assembly.
8. REMOVE SPEED SENSOR NT
(a) Disconnect the speed sensor connector.
(b) Remove the bolt and speed sensor.
(c) Remove the O-ring from the speed sensor.
9. REMOVE SPEED SENSOR NC
(a) Disconnect the speed sensor connector.
(b) Remove the bolt and speed sensor.
(c) Remove the O-ring from the speed sensor.