Matrix FWD L4-2.4L (2AZ-FE) (2009)
Clutch Fluid Accumulator: Service and Repair
Installation
CLUTCH: CLUTCH ACCUMULATOR (for E351): INSTALLATION
INSTALLATION
1. INSTALL CLUTCH ACCUMULATOR ASSEMBLY
(a) Install the clutch accumulator assembly with the 2 nuts.
Torque: 12 Nm (120 kgf-cm, 9 ft-lbf)
2. CONNECT CLUTCH LINE
(a) Connect the clutch tube bracket with the bolt.
Torque: 8.0 Nm (80 kgf-cm, 69 in-lbf)
(b) Using a union nut wrench (10 mm), install the clutch line to the clutch accumulator assembly.
without a union nut wrench - Torque: 15 Nm (155 kgf-cm, 11 ft-lbf)
with a union nut wrench - Torque: 14 Nm (143 kgf-cm, 10 ft-lbf)
NOTICE:
-
Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
-
This torque value is effective when the union nut wrench is parallel to the torque wrench.
3. INSTALL CLUTCH ACCUMULATOR BRACKET