Matrix FWD L4-2.4L (2AZ-FE) (2009)
(a) Using SST and a press, install a new drive shaft dust cover.
SST: 09527-10011
SST: 09726-40010
Distance (A):
26.6 to 27.6 mm (1.05 to 1.08 in.)
3. INSTALL FRONT DRIVE SHAFT DUST COVER RH (for 2WD)
(a) Using SST and a press, install a new drive shaft dust cover RH until the distance from the tip of the center drive shaft to the drive shaft dust
cover RH meets the specification, as shown in the illustration.
SST: 09527-10011
Distance (A):
91.0 to 92.0 mm (3.59 to 3.62 in.)
NOTICE:
-
The dust cover should be completely installed.
-
Be careful not to damage the dust cover.
4. INSTALL FRONT DRIVE SHAFT DUST COVER LH
(a) Using SST and a press, install a new dust cover into the front drive inboard joint assembly until it is flush with the end.
SST: 09527-10011
NOTICE:
-
Install the dust cover in the correct direction.
-
Do not deform the dust cover.
5. INSTALL OUTBOARD JOINT BOOT