Matrix FWD L4-2.4L (2AZ-FE) (2009)
/Page-1329010.png)
(c) Remove SST.
(d) Using SST, measure the clearance of the boot clamp as shown in the illustration.
SST: 09240-00020
Standard clearance:
0.5 to 1.5 mm (0.0197 to 0.0590 in.)
NOTE: If the clearance is outside the specified range, retighten SST.
(e) Check whether the drive shaft dimensions are within the following specifications.
14. INSPECT FRONT DRIVE SHAFT See: Testing and Inspection/Component Tests and General Diagnostics
