Matrix FWD L4-2.4L (2AZ-FE) (2009)
Rear Door Window Regulator: Service and Repair
Removal
WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Rear Door): REMOVAL
REMOVAL
HINT:
-
Use the same procedure for the RH side and LH side.
-
The procedure listed below is for the LH side.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
2. REMOVE REAR DOOR INSIDE HANDLE BEZEL See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Disassembly
3. REMOVE REAR DOOR ARMREST UPPER BASE PANEL See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Disassembly
4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Disassembly
5. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Disassembly
6. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Disassembly
7. REMOVE REAR DOOR SERVICE HOLE COVER (w/o Power Door Lock) See: Body and Frame/Doors, Hood and Trunk/Doors/Rear
Door/Service and Repair/Disassembly
8. REMOVE REAR DOOR SERVICE HOLE COVER (w/ Power Door Lock) See: Body and Frame/Doors, Hood and Trunk/Doors/Rear
Door/Service and Repair/Disassembly
9. REMOVE REAR DOOR WEATHERSTRIP
10. REMOVE REAR DOOR GLASS RUN See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and Repair/Disassembly
11. REMOVE REAR DOOR REAR WINDOW GUIDE SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service
and Repair/Disassembly
12. REMOVE REAR DOOR REAR GUIDE SEAL See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and Repair/Disassembly
13. REMOVE REAR DOOR GLASS SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Disassembly
14. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service
and Repair/Disassembly
15. REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY
(a) Connect a positive (+) lead of the battery to terminal 1, and a negative (-) lead to terminal 2 of the rear power window regulator motor
assembly to move the lift arm to the position shown in the illustration.
(b) Using a "TORX" driver (T25), remove the 3 screws and the rear power window regulator motor assembly.