Matrix FWD L4-2.4L (2AZ-FE) (2009)
/Page-2652001.png)
Washer Fluid Level Switch: Testing and Inspection
WIPER / WASHER: WASHER LEVEL WARNING SWITCH: INSPECTION
INSPECTION
1. INSPECT LEVEL WARNING SWITCH ASSEMBLY
(a) Remove the washer jar.
(b) Disconnect the level warning switch connector.
HINT: The check should be performed with the level warning switch assembly installed to the washer jar.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
If the result is not as specified, replace the level warning switch assembly.
