Matrix XRS 2WD L4-1.8L (2ZZ-GE) (2003)
Drive Belt: Service and Repair
REPLACEMENT
1. REMOVE ENGINE UNDER COVER RH
2. REMOVE WIRE HARNESS CLAMP
a. Disconnect engine wire harness.
b. Remove the bolt and wiring harness clamp bracket.
3. DISCONNECT SUCTION HOSE SUB-ASSY
a. Remove the 2 nuts installing the suction hose sub-assy.
b. Disconnect the suction hose sub-assy.
4. REMOVE FAN AND GENERATOR V-BELT
a. Turn the drive belt tensioner clockwise to relieve tension on the belt, and then remove the belt.
b. Carefully return the tensioner to the unloaded position.
5. INSTALL SUCTION HOSE SUB-ASSY
Torque: 9.8 Nm (100 kgf-cm, 87 inch lbs.)